NordicTrack NTL10224-INT.1 User Manual

9
3. Remove and discard the indicated screw (C) in
the Right Upright (85). Then, attach the ground
wire (D) to the Right Upright with a Ground
Screw (3).
See the inset drawing. Locate the small ear
(E) on the Grommet (86) on the Upright Wire
(82). Insert the ear into the square hole (F) in the
Right Upright (85), and then press the Grommet
into the square hole.
85
2
82
94
2. Make sure that the power cord is unplugged.
Remove any ties securing the Upright Wire (82)
to the right side of the Upright Base (94).
Next, identify the Right Upright (85), and have a
second person hold it near the Upright Base (94).
See the inset drawing. Locate the wire tie (A)
in the Right Upright (85). Tie the wire tie through
the wire pull (B) on the Upright Wire (82). Then,
insert the wire pull and the Upright Wire into the
Right Upright.
Then, pull the upper end of the wire tie (A) until
the Upright Wire (82) is routed through the Right
Upright (85). Do not untie the wire tie yet.
B
A
82
85
85
3
82
3
C
E
F
86
D
85
A
82

NordicTrack NTL10224-INT.1 Specifications

General

Brand	NordicTrack
Model	NTL10224-INT.1
Category	Treadmill
Language	English