Instruction Sheet
Part 1047722A
E 2004 Nordson Corporation
P/N 1047722A
EPC-15 Container Firmware Chip Installation
WARNING: Allow only qualified personnel
to perform the following tasks. Follow the
safety instructions in this document and all
other related documentation.
Kit Contents
The EPC-15 Container firmware chip kit,
part 1047694, consists of these items:
S Firmware chip
S Chip removal tool
S Grounding wrist strap
S Firmware identification label
The firmware chip contains the software necessary
to use the EPC-15 Eclipse Series pattern controller
with a container coating system.
Installation
WARNING: Disconnect and lock out
power before performing the following
tasks. Failure to observe this warning
could result in equipment damage,
personal injury, or death.
1. See Figure 1. Remove the three screws (1)
securing the lower housing (2) to the controller.
2. Pull the lower housing down to disengage its
tabs from the controller and remove it.
3. Remove the two screws (3) securing the upper
housing (4) to the controller. Swing the upper
housing up.
1200455A
1
2
3
4
5
Figure 1 Removing the Upper and Lower Housings
1. Screws (3)
2. Lower housing
3. Screws (2)
4. Upper housing
5. Firmware identification
label
Note: The firmware identification label is included with
the service kit.
To Next Page
Need help?
General
