Notifier AFP-400 Product Installation Guide

Page 2 of 2 Doc. 50392:B 03/06/97
Mount a cabinet on a surface in a clean, dry, vibration-free area. To install the
cabinet so the center of the control panel keypad measures 60 inches above the
finished floor, follow these instructions:
1) Locate the cabinet so that the top edge is 66 inches above the surface of the
finished floor.
2) Mount the backbox using the four mounting holes in the back surface of the
backbox.
Dress Panel
Door
!
Caution: Unless you are
familiar with the place-
ment of components
within this backbox, use
only the knockout
locations provided for
conduit entry.
Assembling the Cabinet
Assemble the cabinet as follows.
1) Install the Dress Plate mounting screws.
2) Install control panel components (refer to the AFP-300/AFP-400 Installation
Manual).
3) Install the Dress Panel and tighten the mounting screws.
4) Place the door on the hinge pins.
Mounting the Cabinet
Door hinge
(2 places)
Mounting the Cabinet
Dress Panel
mounting screw
Assembling the Cabinet
Technical Manuals Online! - http://www.tech-man.com

Notifier AFP-400 Specifications

General

Brand	Notifier
Model	AFP-400
Category	Control Panel
Language	English