3
BRAKE CABLE REPLACEMENT INSTRUCTIONS
FOR 4010/4202/4202C/4203/4204/4207/4208/4212/4214/4215/4216/4218/4220/4222/4224/4700/4900
_______________________________________________________________________________________________
______________________________________________________________________________________________
STEP 14 (4010/4202C/4203) – USE PLIERS TO
PULL DOWN ON THE CABLE AND PUSH DOWN
ON THE BRAKE SHOE UNTIL IT TOUCHES THE
WHEEL.
STEP 14 -
(4202/4207/4208/4212/4214/4215/4216/4700) PULL
DOWN ON THE CABLE TO REMOVE ALL OF THE
SLACK.
STEP 15 – CONTINUE PULLNG DOWN ON THE CABLE WHILE
TIGHTENING THE SCREW HEAD AGAINST THE CABLE.
STEP 15 – (4202/4207/4208/4212/4214/4215/4216/4700) CONTINUE
PULLING DOWN ON THE CABLE AND TIGHTEN THE ALLEN
SCREW HEAD AGAINST THE CABLE.
STEP 17 – RELEASE THE HAND BRAKE
FROM THE LOCKED POSITION AND UN-
SCREW THE TENSION ADJUSTMENT
SCREW UNTIL THE DESIRED TENSION
IS ACHIEVED. THE BRAKE SHOULD
STOP THE WHEEL WHEN THE HANDLE
IS IN THE LOCKED POSITION.
STEP 18 – SCREW THE LOCKING NUT
AGAINST THE BRAKE CASING TO
SECURE YOUR DESIRED BRAKE
ADJUSTMENT.
STEP 19 – CUT THE BRAKE
CABLE APPROXIMATLY 1”
BELOW THE BRAKE SHOE
STEP 20 – REPLACE THE CRIMP ON THE END OF THE CABLE
AND SQUEEZE THE THIN END OF THE CRIMP TO ATTACH IT.
STEP 16 – RE-ATTACH
THE BRAKE SPRING TO
THE WALKER FRAME
To Next Page
Loading...
Need help?
General
