4
TOP PANEL FEATURES
1. POWER LED – Illuminates
when the mixer is on.
2. MIC TREBLE – Adjusts the
high (treble) frequencies of the
microphone channel.
Tip: If you experience feedback
when using a microphone at
loud levels, try turning down the
high frequencies.
3. MIC BASS – Adjusts the low
(bass) frequencies of the
microphone channel.
4. MIC GAIN – Adjusts the audio
level of the microphone signal.
5. INPUT SELECTOR – Selects
the input source to be routed to
the corresponding channel.
Input jacks are located on the
rear panel.
6. CHANNEL GAIN – Adjusts the
corresponding channel’s pre-
fader and pre-EQ gain level.
7. CHANNEL TREBLE – Adjusts
the high (treble) frequencies of
the corresponding channel.
8. CHANNEL MID – Adjusts the
mid-range frequencies of the
corresponding channel.
9. CHANNEL BASS – Adjusts the
low (bass) frequencies of the
corresponding channel.
10. CHANNEL FADER – Adjusts
the audio level on the
corresponding channel.
11. CUE MODE SELECTOR – Selects the audio that is sent to the headphones. Switch it to “CH1”, “CH2,” or
“CH3” to hear Channels 1, 2, or 3 in the Cue channel.
12. CUE BLEND – Turn to mix between Cue and Program in the headphones. When all the way to the left, only
channels routed to CUE will be heard. When all the way right, only the Program mix will be heard.
13. CUE GAIN – Adjusts the level of the headphone audio.
14. MASTER – Adjusts the output volume of the Program mix.
15. STEREO LEVEL INDICATOR – Measures the audio level of the Program mix.
16. METER ASSIGN – Determines whether audio from the Program mix or the Cue channel is sent to the
STEREO LEVEL INDICATOR.
17. HEADPHONES – Connect your ¼” headphones to this output for cueing and mix monitoring. Headphone
output controls are located on the top panel.
18. CROSSFADER – Blends audio playing between Channels 1 and 3. Sliding this to the left plays Channel 1 and
sliding to the right plays Channel 3.
Note: The crossfader is user-replaceable if it should ever wear out. Simply remove the facepanel, then remove
the screws holding it in position. Replace the fader with a quality authorized replacement from your local
Numark retailer only.
19. CROSSFADER (CF) SLOPE – Adjusts the slope of the crossfader curve. Flip switch to the left for a smooth
fade (mixing) or to the right for a sharp cut (scratching).
20. CROSSFADER (CF) MODE – Reverses the assignment of Channels 1 and 3 on the crossfader.
1
5
18
17
5 5
2
3
4
6
7
8
9
10
6
7
8
9
10
6
7
8
14
16
11
15
13
12
9
10
19
20
To Next Page
Loading...
Need help?
General
