SPECIFICATION
FUNCTION
1. Browser Knob ----------------Rotate this knob to cycle through folders and tracks. Press the Knob To cycle between the
Crates and Library.
2. Master Gain --------------------Adjusts the master volume in the software.
3. Cue Mix ------------------------Adjusts the software’s audio output to the headphones, mixing between the cue output and the
master mix output.
4. Cue Gain -----------------------Adjusts the volume for headphone cueing in the software.
5. Load ----------------------------Press one of these buttons while a track is selected to assign it to Deck 1 and 2,respectively, in
the software.
6. High EQ -----------------------Controls the treble frequencies for the individual channels.
7. Mid EQ-------------------------Controls the mid range frequencies for the individual channels.
8. Low EQ ------------------------Controls the bass frequencies for the individual channels.
9. Filter ----------------------------Adjusts the amount of the filter effect. Turning the knob left and right will produce a
Low Pass Filter or High Pass Filter.
10. Cue/PFL ----------------------Sends pre-fader audio to the Cue Channel for headphone monitoring.
11. Channel Volume-------------Adjusts the volume of the individual channels in the software.
12.Cross Fader--------------------Controls the blend between the two decks.
13. Platter/Jog---------------------This capacitive, touch-sensitive jog wheel controls the audio when the wheel is touched and
moved. When the Wheel button is not active, use the jog wheel to bend the pitch of the track.
When the Wheel button is active, use the jog wheel to grab and move the audio, "scratching"
the track as you would with a vinyl record. You can also grab the non-touch-sensitive outer
wheel to bend the pitch of the track.
14. Pad Mode---------------------This is used to change the operation of the top 4 performance pads.
15.Play/Pause---------------------Starts and suspends playback. Hold Shift + Play/Pause to stutter the track from the last set cue
point. If a cue point has not been set, the play head will return to the start of the track.
16. Performance Pads-----------The top row of pads is used to trigger autoloop points. The bottom row of pads is used to
trigger
Cue points. If a Cue point has not already been set for the loaded track, this control will mark
the
Cue point. If a Cue point has already been set, this control will jump to Cue point.
MODEL: MIXTRACK3
To Next Page
Need help?
General
