SPECIFICATION
FUNCTION
1. UI Browser – A standard detented encoder with push switch is used to navigate through the software. Push encoder to move in the software.
2. LOAD BUTTONS –Push twice to perform instant doubles to the deck in focus. Song will load to the deck(s) currently in focus.
3. Gain – This pot controls the gain for its associated channel on the mixer.
4. Channel Fader – This is the volume controller for the channel.
5. Cue Mix–Selects Master or PFL outputs in the headphones.
6. Cue Gain–adjusts volume of headphone pot.
7. Software FX Wet/Dry – This knob Adjusts the Wet/Dry of all FX.
8. Mic/Aux volume – Controls mic volume.
9. Mic/Aux Tone – Controls the high and low EQ mix for mic
10. Master volume – Controls program signal + Mic mixed with mic going to XLR on rear
11. Booth/Zone Output – Controls program signal+ Mic mixed with mic going to RCA on rear
12. Crossfader Assign – select crossfader left-off-right assign
13. DJ Mic volume – Controls mic volume.
14. DJ Mic Tone – Controls the high and low EQ mix for mic
AUDIO OUTPUT
LINE OUT
OUTPUT LEVEL--------------------MASTER:1.3 ± 0.5V
BOOTH:1.3 ± 0.5V
BALANCED:4V ±0.5V
THD+N%------------------------------LESS THAN 0.5%
S/N--------------------------------------MORE THAN 85 dB
SEPARATION------------------------MORE THAN 70 dB
FERQUENCY RESPONSE---------20~20KHz ± 2 dB
MIC IN
OUTPUT LEVEL--------------------MASTER:185mV ±50mV
BOOTH: 185mV ±50mV
BALANCED:1.1V ±0.5V
THD+N%------------------------------LESS THAN 0.5%
SEPARATION------------------------MORE THAN 60dB
FERQUENCY RESPONSE---------20~20KHz ± 2 dB
HP OUT
OUTPUT LEVEL--------------------BALANCED:7V ±1V
THD+N%------------------------------LESS THAN 0.5%
S/N--------------------------------------MORE THAN 85 dB
SEPARATION------------------------MORE THAN 70 dB
FERQUENCY RESPONSE---------20~20KHz ± 2 dB
SERVICE MANUAL
MODEL: NS4FX
To Next Page
Loading...
Need help?
General
