Numark NS6 Control Manual

2
Installation & Setup
1. Download and install Serato DJ from serato.com/dj/downloads.
2. NS6 requires drivers for both Mac and Windows. Go to numark.com/ns6 and see the
Downloads section of the page. If the NS6 driver for your operating system is not the latest,
please download and install the latest driver.
3. After installing the driver, connect your NS6 to your computer's USB port, and power on
NS6.
4. Open Serato DJ.
Note: NS6 does not require a Serato DJ license purchase. When you first open Serato DJ, a
license panel appears on the right hand side, and the software will be in Library View Mode.
Simply check the Do Not Show Again box in the lower right corner, and then click License
to hide this panel. Serato DJ will remember these settings.
To then change the view mode:
• Press NS6's VIEW button.
• Use the drop-down menu in the upper left corner in Serato DJ.

Numark NS6 Specifications

General

Sample rate	441 kHz
Channels quantity	4 channels
Digital sound processing	24 bit
MIDI out	Yes
Booth out (1/4\")	1
Dimensions (WxDxH)	603 x 340 x 64 mm

Weight and Dimensions

Weight	6330 g