Ohmic instruments UPM-DT-10PA User Manual

7
Front
1. Power – Zero Button:
- Press to power on the UPM-DT-xPA and/or to zero the reading.
- Press and hold until OFF is displayed then release to power off the
UPM-DT-xPA.
2. Print – Unit Button:
- Press to print data via the RS232 port (see the Printing and
Communications section).
- Press and hold to display “Unit” menu, then press the “No” or “Back”
buttons to cycle through the available units. Press the “Yes” button
to select the desired unit. To select watts as the unit of measure,
select the custom unit within the “Unit” menu.
3. Function - Mode Button:
Note: this button should not be used unless cycling through a menu
or returning to “Weighing” mode.
- Press and hold to access the Mode menu to change the type of
weighing. Weighing mode is on by default and the mode that must
be used in standard operation.
4. Tare - Menu – Cal Button:
- Press to tare the scale at the current weight.
- Press and hold to access the various calibration and setup menus
(for authorized service personnel only).
METER LAYOUT
5
3
1
2
4
6
7

Ohmic instruments UPM-DT-10PA Specifications

General

Brand	Ohmic instruments
Model	UPM-DT-10PA
Category	Measuring Instruments
Language	English