About the Control Panel 1-7
When cleaning the print head window
Hold down the Rotate Toner key for 5 seconds to 10 seconds.
The printer enters Print Head Cleanup mode.
" For details on cleaning the print head window, refer to “Cleaning the
Print Head Window” on page 6-8.
" To return to normal operation mode from Print Head Cleanup mode,
refer to “Cleaning the Print Head Window” on page 6-8.
" Print Head Cleanup mode is a mode that allows the user to clean the
print head window more easily. The print head window is not cleaned
automatically.
When replacing all toner cartridges at the same time
Hold down the Rotate Toner key more than 10 seconds.
The printer enters Eject All Toner mode.
" For details on replacing all toner cartridges at the same time, refer to
“Replacing All Toner Cartridges at the Same Time” on page 5-9.
" To return to normal operation mode from Eject All Toner mode, press
the Cancel key.
About the Cancel KEY
The Cancel key allows you to:
Continue a print job after addressing an error message
Cancel a print job
Reset the printer after a toner cartridge is replaced
" For details on resetting the printer after replacing a toner cartridge,
refer to
“Replacing a Toner Cartridge” on page 5-4.
Continuing a Print Job after an Error Message
You can continue a print job after correcting the following types of errors:
No more media in the tray
Media other than that set in the printer driver was fed into the printer
" For details on the error messages, refer to “Indicator Messages” on
page 7-5.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
