Hole Punch Kit (P/N 42872902)
Technician’s Installation Guide
1. Unpack the Hole Punch Kit and check the
contents:
[
1
] Hole Punch Unit
[
2
]Safety Labels
[
3
] Screw (for securing hole punch unit to finisher:
see step 14)
[
4
]Orange Cable (4 leads)
[
5
] Purple Cable (5 leads)
2. Remove the packing tape, blue spacers and
any other packing materials from the Hole
Punch Unit.
3. Turn off the printer.
4. On the back of the finisher/inverter unit,
unplug the inverter power cord (
1
) and the
connecting cord (
2
) to the finisher.
To Next Page
Need help?
General
