....
..
.
..
.
..
3.
Push in the button at the end of the lever and release
it.
The
CRUISE light on the instrument panel will
come on.
4.
Take your foot off the accelerator pedal.
Resuming
a
Set Speed
Setting the cruise control at a desired speed and then
applying the brake will end the cruise control function.
Once you’re going about
25
mph
(40
km/h) or more,
you can move the cruise control switch from
ON
to
RES/ACC (Resume/Accelerate) briefly to reset. This
returns you to your desired preset speed.
Remember, if you hold the switch at RES/ACC briefly,
the vehicle will accelerate until you release the switch or
apply the brake.
So
unless you want to go faster, don’t
hold the switch at RES/ACC.
Increasing Speed While Using Cruise Control
There are two ways to go to a higher speed.
Use the accelerator pedal to
go
to
a higher speed.
Push the button at the end of the lever, then release
the button and the accelerator pedal. You’ll now
cruise at the higher speed.
01;
0
Move the cruise switch from
ON
to RES/ACC.
Hold
it
there until you reach a desired speed and then
release the switch. Or, to increase your speed in very
small amounts, move the switch to RES/ACC briefly
and then release it. Each time you do this, your
vehicle will
go
about
1
mph
(1.6
km/h)
faster.
The accelerate feature will only work after you have set
the cruise control speed by pushing the SET button.
To Next Page
Loading...
Need help?
General
