13
En
1 Press Y# repeatedly to select the flash mode and press i.
2 Press the shutter button halfway.
When the flash is set to fire, the # mark lights.
3 Press the shutter button completely to take the picture.
Flash working range:
W (max.):Approx. 4.0 m (13.1 ft.)
T (max.): Approx. 2.5 m (8.2 ft.)
1 Press NY to select [Y ON] and press i.
2 Press the shutter button fully to take the picture.
The self-timer lamp lights for approximately 10
seconds after the shutter button is pressed, then starts
blinking. After blinking for approximately 2 seconds,
the picture is taken.
To save battery power, the camera automatically enters sleep mode and stops
operating if not used for approximately 3 minutes. Operate the shutter button or
zoom button to reactivate the camera.
If the camera is not operated for approximately 15 minutes after the camera enters
sleep mode, it automatically retracts the lens and turns off. To resume operation,
turn on the power again.
Icon Flash Mode Description
No
indication
Auto flash The flash fires automatically in low light or backlight
conditions.
!
Red-eye
reduction flash
The red-eye reduction flash mode significantly reduces this
phenomenon by emitting pre-flashes before firing the
regular flash.
#
Fill-in flash The flash fires regardless of the available light.
$ Flash off The flash does not fire even in low light conditions.
Flash Modes
Self-Timer
Self-Timer Lamp
Power Save Feature
d4312_e_basic_00_bookfile_7.book Page 13 Tuesday, December 27, 2005 4:13 PM
To Next Page
Loading...
Need help?
General
