Menu operations
EN
25
The pixel mapping feature allows the camera to check and adjust the CCD and image
processing functions. It is not necessary to operate this function frequently. Approximately
once a year is recommended. Wait at least one minute after taking or viewing pictures to
allow the pixel mapping function to perform properly. If you turn the camera off during pixel
mapping, start again.
Select [PIXEL MAPPING]. When [START] is displayed, press H.
•Press ON to adjust the volume.
• You can adjust the volume to one of five levels or mute the
volume.
PIXEL MAPPING .................................................. Adjusting the image processing function
K/q.........................................................Turning on the camera with the K or q button
YES Pressing K turns on the camera and starts the camera in the shooting mode.
Pressing q turns on the camera and starts the camera in the playback mode.
NO The power is not turned on. To turn on the camera, press o.
s........................................................................................... Adjusting the monitor brightness
BRIGHT/
NORMAL
BEEP.....................Adjusting the volume of operation sound when the buttons are pressed
OFF (No sound)/
LOW /HIGH
8....................................................................Adjusting the volume of camera warning sound
OFF (No sound)/
LOW / HIGH
SHUTTER SOUND............................................ Adjusting the volume of the shutter button
OFF (No sound)/
LOW / HIGH
VOLUME.......................................................................Adjusting the volume during playback
OK
MENU
2
1
3
BEEP
SHUTTER SOUND
VOLUME
SET
BACK
d4347_e_0000_7.book Page 25 Tuesday, July 17, 2007 11:23 AM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
