Using OLYMPUS Master
EN
39
Please take care that your battery is fully charged!
1 Make sure that your computer is connected to the Internet.
2 Plug the USB cable into the USB port on the computer.
3 Plug the other end of the USB cable into the camera’s USB connector.
• The camera turns on automatically.
• The monitor turns on and the selection screen for the USB connection is displayed.
4 Select [PC], and press H.
5 In the browse window, select “Camera”, then “Update Camera/Add
Display Language”.
• The confirmation window for updating is displayed.
6 Click “OK”.
• The updating the camera window is displayed.
7 Click “Add Language” in the
updating camera display.
• The “Add Display Language of Camera”
window is displayed.
8 Click and select a language.
9 Click “Add”.
• The new language is downloaded to your camera.
Please do not remove any cable or the battery while
the camera is processing.
10After the download procedure the camera
display will show “OK”. You can remove the cables and turn power off.
After restarting the camera you will be able to choose the new language
from [SET UP].
To increase the number of languages
d4347_e_0000_7.book Page 39 Tuesday, July 17, 2007 11:23 AM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
