CL3515R K/J/T/E/R/S/N/L/U/B/C Calibrator Thermometer
GENERAL SPECIFICATIONS
Displays:
There are three different display areas, Main Second and Third. The Main and Second
display panels are 4 1/2 digit liquid crystal display (LCD) with maximum reading of
19999. The main is used for displaying the value of T1, T2 or output setting. The
second displays T1 or T2 readings and the third T1-T2 and groups settings.
Battery:
Standard 9V battery (NEDA 1604, IEC 6F22 006P). Battery life is about 17.5 hours
when used with a carbon zinc battery.
Low battery indication:
The "
" is displayed when the battery voltage drops below the operating level.
Dimensions: 192mm(H) x 91mm(W) x 52.5mm(D).
Weight: 320g.
EMC:
Through the RS radiation interference test the frequency of 80MHz to1000MHz, the
measurement number producing the unsteady flutter, it immediately recover after stop
the test.
Accessories:
Two type “K” thermocouple bead wires. Two type “K” thermocouple calibration bead
wires. Maximum insulation temperature 260°C (500°F). Wire accuracy ±2.2°C or
±0.75% of reading (whichever is greater) from 0°C to 800°C.
A 9 volts battery.
An instruction manual.
Pc connection software.
Pc interface cable.
ENVIRONMENTAL
Ambient Operating Ranges:
0°C to 50°C (32°F to 122°F) <80% R.H.
Storage Temperature:
-20°C to 60°C (-4°F to 140°F) <70% R.H.
Input Connector:
Accepts standard miniature thermocouple connectors (flat blades spaced 7.9mm,
center to center).
2
CL3515R K/J/T/E/R/S/N/L/U/B/C Calibrator Thermometer
Type
K, J, T, E, R, S, N, L, U, B, C, mV
Step Item
Step 1 to Step 10
Edit
Default
CL3515R setting values.
Clear
Clear the current group.
Clear All
Clear all group’s value.
7. File
Load
From PC load the stored value.
Save
Save the setting value into PC.
Setup
15
To Next Page
Loading...
Need help?
General
