Connecting Online from the CX-Programmer
Connecting Online from the CX-Programmer
The USB-Serial Conversion Cable uses one of the computer's COM ports to
communicate. The communications port (COM port) allocated to the Conversion Cable
must be selected with the CX-Programmer in order to connect online to a PLC or PT.
Note: It may take some time for the computer to detect the cable after the cable is connected. This
is not a malfunction.
█ Selecting the Cable's COM Port in CX-Programmer
Use the following procedure to select the COM port used by the Conversion Cable.
1. Display the Change PLC dialog box.
2. Click the Settings button in the Network Type area. Select the desired type of
network.
The Network Settings dialog box will be displayed.
3. Click the Driver tab in the Network Settings dialog box.
34
To Next Page
Loading...
Need help?
General
