H5L
3
Nomenclature
Key Operation
Mode Key
Write Key
Plus Key
Minus Key
Cycle Key Manual override switch
LCD
Note: This figure shows the LCD section with all display items
being displayed on the screen.
Key Name Function
Mode Key
Write Key To write the set data using the Plus and/or Minus Key.
Reads out the set program.
Plus Key Changes “day of week” while setting day of week.
Changes “hours” or “minutes” while setting current time.
When the Plus Key is held down, the displayed digit increments continuously; when the Minus Key is held
down, it decrements continuously.
When specifying output.
The Plus Key specifies output ON while the Minus Key specifies output OFF.
Note that if the same key is pressed twice, the output specification becomes invalid; neither ON nor OFF is
set.
Minus Key
Cycle Key Specifies the cycle program. Pressing this key twice causes the set cycle program to be cleared.
Manual override
switch
ON: Turns ON output regardless of program
RUN: Executes program
OFF: Turns OFF output regardless of program
First and second circuit can be operated independently.
Changes program mode
To Next Page
Loading...
Need help?
General
