11
Assembly steps
EN
STEP 3 – Snap either electrode cord to each of the pads
For the ¿ rst time, take the pads out of the sealed package.
Do not turn the unit on, until pads are on your skin.
You must use both pads or stimulation will not work.
STEP 4 – Remove and discard plastic ¿ lm from pads (in case of new pads)
Remove the clear plastic ¿ lm from the back of the pad.
Discard the plastic ¿ lm backing as well as the clear packaging.
STORING PADS ON PAD HOLDER
After using, put sticky side of pads on either side of the pad
holder.
STEP 5 (Optional) – Attach the unit to the belt clip
The clip may fall off if attached to soft or thin clothing.
Pad facing down
Pad Holder
Pad sticky side up
To Next Page
Loading...
Need help?
General
