3-2
FIRE EXTINGUISHER PORT
A genset with an enclosure has a fire extinguisher
port accessible by breaking through the circle on the
warning label located as shown in Figure 3-2. Make
sure that the nozzle of the fire extinguisher that
will be used in the event of fire is smaller than
the circle so that it will fit through the port. The
fire extinguisher must be of the gaseous type.
In the event of fire:
1. DO NOT open the genset enclosure.
2. Shut down engines, generators and blowers.
3. Break through the circle on the label with the
nozzle and discharge the full contents of the fire
extinguisher.
FIGURE 3-2. FIRE EXTINGUISHER PORT
Redistribution or publication of this document,
by any means, is strictly prohibited.
To Next Page
Loading...
Need help?
General
