22
Connecting Other Components—Continued
The following diagram shows how to connect an optional Onkyo RI Dock (Remote Interactive Dock).
Connect the CD receiver’s DOCK/CDR IN jacks (DOCK IN jacks on the CR-315) to the RI Dock’s AUDIO OUT jacks.
What can you do with ?
• Connecting an Onkyo RI Dock to the CD receiver with an cable allows you to control the RI Dock with the CD
receiver’s remote controller. In addition, when playback is started on the RI Dock, the CD receiver will automatically
select it as the input source.
•To use , you must connect the RI Dock to the CD receiver with an cable and an analog audio cable (RCA).
On the RI Dock, set the MODE switch to “HDD.” See the RI Dock’s instruction manual for details.
CR-515
•To use , the Input Display for the DOCK/CDR jacks must be set to “DOCK.” Since this is the default setting,
unless you’ve changed it, it can be left as it is (see page 29).
Connecting an Onkyo RI Dock (Remote Interactive Dock)
IN
IN
OUT
R
DOCK
MD/
TAPE
L
IN
IN
R
LINE 1
MD/
TAPE
L
IN
OUT
OUT
DOCK/
CDR
R
AUDIO OUT DC INS VIDEO OUT
----
L
R
AUDIO OUT DC INS VIDEO OUT
----
L
: Signal flow
CR-515’s
rear panel
White
Red
Red
White
Analog audio cable (RCA)
cable supplied
with the RI Dock
Onkyo RI Dock’s rear
panel
CR-315’s
rear panel
White
Red
Red
White
Analog audio cable (RCA)
cable supplied
with the RI Dock
Onkyo RI Dock’s rear
panel
To Next Page
Loading...
Need help?
General
