21
Wireless connection
■ Using Access Point Mode
1
Confirm that LED lights up in green.
LED lighting in blue indicates that connection to
network has been completed.
Note
• If Ethernet cable is being connected to the
DS-A5, pull the Ethernet cable out after turning
the power of DS-A5 off, and turn the power on
again and make the settings.
2
Press the ENTER button on the remote
controller for five seconds.
The DS-A5 goes into Access Point mode and
wireless connection from your personal
computer enables thanks to the DS-A5’s SSID.
LED blinks in green.
3
Access the WEB settings menu (➔page 22)
from your personal computer and make
wireless settings.
LED lights up in blue once the connection
completes.
Tip
• You can also display the WEB settings menu by
entering the DS-A5’s IP address “192.168.1.1” in
the browser’s Internet address (URL) field
through Internet browser such as Internet
Explore
®
.
To Next Page
Loading...
Need help?
General
