Onkyo HT-R370 User Manual

37
First Time Setup—Continued
Notes:
• Make sure you also set your digital sources to send out
a digital signals. Please refer to the digital sources’
manual.
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
If you connect an u-capable Onkyo MiniDisc
recorder, CD recorder, or RI Dock to the TV/TAPE
IN/OUT jacks, or connect an RI Dock to the CBL/SAT
IN or VCR/DVR IN jacks, for u to work properly, you
must change this setting.
This setting can only be changed on the AV receiver.
Note:
DOCK can be selected for the TV/TAPE or CBL/SAT or
VCR/DVR input selector, but not at the same time.
2
Use the Up and Down [q]/[w]
buttons to select “2.Digital
Audio”, and then press [ENTER].
3
Use the Up and Down [q]/[w]
buttons to select an input
selector, and then use the Left
and Right [e]/[r] buttons to
select:
COAX: Select if the component is
connected to DIGITAL IN
COAXIAL.
OPT1: Select if the component is
connected to DIGITAL IN
OPTICAL 1.
OPT2: Select if the component is
connected to DIGITAL IN
OPTICAL 2.
-----: Select if the component is
connected to an analog input.
4
Press the [SETUP] button.
Setup closes.
Changing the Input Display
1
Press the [TV/TAPE], [CBL/SAT]
or [VCR/DVR] input selector
button so that “TV/TAPE”,
“CBL/SAT” or “VCR/DVR”
appears on the display.
2
Press and hold down the
[TV/TAPE], [CBL/SAT] or
[VCR/DVR] input selector button
(about 3 seconds) to change the
setting.
Repeat this step to select MD, CDR, or
DOCK.
For the TV/TAPE input selector, the
setting changes in this order:
For the CBL/SAT input selector, the
setting changes in this order:
CBL/SAT
l DOCK
For the VCR/DVR input selector, the
setting changes in this order:
VCR/DVR
l DOCK
CBL/SAT
VCR/DVR
TV/TAPE
oror
or
oror
or
TV/TAPE o MD o CDR
DOCK
o
o

Onkyo HT-R370 Specifications

General

Brand	Onkyo
Model	HT-R370
Category	Home Theater System
Language	English