14
Troubleshooting
• Make sure your iPod is connected properly.
• If there’s no video, make sure you iPod sup-
ports TV out.
• Make sure your iPod is playing.
• Make sure your amp or AV receiver is turned
on, the input to which the ND-S1 is con-
nected is selected as the input source, and
the volume control is not set to minimum.
• Make sure all plugs are pushed in all the way.
• Make sure the ND-S1 is connected to the cor-
rect input jacks on your amp or AV receiver. If
there’s no video, check your video connec-
tions. Do not connect the ND-S1 to any jacks
on your amp or AV receiver labeled OUT.
• Make sure the AC adapter is properly con-
nected to the ND-S1 and a suitable wall out-
let.
• Try resetting your iPod.
• If you remove then re-insert your iPod, it may
not be recognized temporarily. In this case,
press and hold down the ND-S1’s [iPod] but-
ton for at least 2 seconds to reset the ND-S1.
If it’s still not recognized, disconnect the USB
cable and AC adapter, then reconnect them.
• Make sure your iPod is seated properly on
the dock connector. If your iPod is in a case, it
may not connect properly, so always remove
the case before inserting your iPod into the
ND-S1.
• Your iPod cannot be controlled while it’s dis-
playing the Apple logo.
• If your remote controller has Remote Mode
buttons, make sure the mode necessary to
control your iPod is selected.
• If you’re using the remote controller that
came with your amp or AV receiver, be sure
to point it toward your amp or AV receiver
when you want to control your iPod.
• An cable connection is required with
some components, but not others. If you
connect it by mistake, remote control may
not work. See page 8 for details.
• Try resetting your iPod.
• Before using one of the other components
connected to your amp or AV receiver, stop
playback on your iPod. If playback is not
stopped, the Direct Change function may
select your iPod as the input source by mis-
take at the transition between songs.
• Depending on the backlight setting on your
iPod, the display may become dim during
use. If the display is hard to see, change the
backlight setting on your iPod.
• Do not use Cover Flow while playing music
on your iPod, as it may stop iPod playback or
cause noise.
No Sound or Video Remote Controller doesn’t work
Others
To Next Page
Loading...
Need help?
General
Weight and Dimensions
