______________________________________________________________________________________
MACHINE MAINTENANCE
______________________________________________________________________________________
Follow the daily, weekly and monthly maintenance procedures to keep the machine in good condition.
Warning: Electric shock hazard. Please firstly disconnect the battery wring before maintaining the machine.
DAILY MAINTENANCE:
1. Drain and clean the wastewater tank.
2. Dismantle and flush the floating filter screen in the wastewater tank.
3. Drain the clean water tank and flush the water tank with hot water of no higher than 140F as required.
4. Dismantle the scouring pad/brush for cleaning. If there is any abrasion, overturn or replace the scouring
pad.
5. Wipe the squeegee adhesive tape. Place the squeegee component in the rising position to avoid
damage to adhesive tape.
6. Check the abrasion conditions of the scraper edge of the squeegee adhesive tape. If there is any wear
and tear, exchange two sides of the adhesive tape.
7. Use multi-purpose detergent and wet cloth to wipe the machine. For safety: please do not spray this
machine with high pressure or flush this machine with water pipe when cleaning the machine to avoid
failure of electronic component.
8. Check the abrasion conditions of the skirt side of the brush head and replace it if there is any wear and
tear or damage.
9. Charge the battery. To prolong the life of the battery and ensure the optimum efficiency of the
machine, the battery must be charged after the use time of the machine exceeds 30min.
MONTHLY MAINTENANCE:
1. Dismantle the filter of the clean water tank from the bottom of the machine and clean the filter screen.
Ensure the clean water tank is emptied before dismantling the filter.
2. Clean the top of the battery to prevent electrode corrosion (refer to [Battery Maintenance]).
3. Check whether the battery wiring is loose.
4. Check and clean the cover seal of the wastewater tank and replace it if there is any damage.
5. Spray the silica gel dry lubricant on all pivots and wheels and cover a layer of water-proof lubricating oil
to ensure smooth operation of wheels and pivots.
6. Check whether the nuts and bolts on the machine are loose.
7. Check whether the machine leaks.
QUARTERLY MAINTENANCE:
Please contact your local service center every 250 hours for a machine inspection of brush and drive motors.
Warning: Electric shock hazard. Please firstly disconnect the battery wring before maintaining the machine.
To Next Page
Loading...
Need help?
General
