Name: ooznest WorkBee CNC
Brand: ooznest
Rating: 4 (1 reviews)

To Next Page

To Previous Page

WorkBee CNC Limit Switches & Wire Routing 11

2.2.4 Screw Driven - Y-Axis Wire Routing - Part 1

A. Connect the two stepper motor wires in the Y-Drag-Chain to the pigtails on the Y-Axis

stepper motors. In Section 2.1.5 Step B, one of the stepper motor wires will be longer

than the other, the longer wire should connect to the right hand stepper motor.

B. Secure the stepper motor wires to the Y-Axis-Fixed-End-Mount using Cable-Tie-

Smalls. The wire for the right hand stepper motor can be tucked into a slot on one of

the extrusions along the back.

C. Secure the lead on the Y-Axis limit switch to the Y-Axis-Fixed-End-Mount using a

Cable-Tie-Small.

Other manuals for ooznest WorkBee CNC

Questions and Answers:

Need help?

Do you have a question about the ooznest WorkBee CNC and is the answer not in the manual?

General