Optimum CNC Controller VI User Manual

OPTIMUM
MASCHINEN - GERMANY
29 / 11 / 2006
Page
2
CNC Controller III and VI ; Version 2.0.1
© 2006
GB
Preface
We thank you very much that you have decided to buy the CNC Controller made by Optimum
Maschinen Germany GmbH.
Changes The illustration of the CNC Controller might in some details deviate from the illustrations of this
operating manual but this will have no influence on the operation of the CNC Controller.
Any changes in the construction, equipment and accessories are reserved for reasons of
enhancement. Therefore, no claims may be derived from the indications and descriptions.
Errors excepted!
We wish you lots of success!
Table of contents
1 General warning notes ...................................................................................................................... 3
1.1 Proper use ............................................................................................................................. 3
2 Assembly and function ...................................................................................................................... 4
3 Capacity and general data ................................................................................................................. 4
4 Unpacking and connection ................................................................................................................ 4
4.1 Delivery volume ...................................................................................................................... 4
4.2 Commissionning ..................................................................................................................... 4
4.2.1 Safety ................................................................................................................... 4
5 Connections ....................................................................................................................................... 5
5.1 CNC Controller III ................................................................................................................... 5
5.2 CNC Controller VI .................................................................................................................. 5
6 Description of the connection ............................................................................................................ 5
6.1 Signal configuration on the parallel port ................................................................................. 6
6.1.1 Assignment of the signals at the parallel port, CNC controller III (port / PC) ....... 6
6.1.2 Assignment of signals at the port reference switch (Ref.switch) .......................... 6
6.1.3 Assignment of signals at the parallel port 1, CNC controller VI (port / PC) .......... 7
6.1.4 Assignment of signals at the parallel port 2, CNC controller VI (port / PC) .......... 7
6.1.5 Optional 4th axis on parallel port 1 ...................................................................... 8
6.1.6 Activating the 4th axis .......................................................................................... 8
7 Control boards.................................................................................................................................... 9
7.1 Compatibility of the control board version 1 and version 2 with CNC controllers ................... 9
7.1.1 Modification of a control board of the version 1 ................................................... 9
7.2 Control board version 1 ........................................................................................................ 10
7.2.1 Setting jumpers .................................................................................................. 10
7.2.2 Operating current and holding current ............................................................... 11
7.3 Control board version 2 ........................................................................................................ 12
7.3.1 Setting the jumper .............................................................................................. 12
7.3.2 Operating current and holding current ............................................................... 13
7.4 Replacing a control board ................................................................................................... 14
8 Connection of the step motors ........................................................................................................ 14
8.1 Cabling X / Y / Z-axis ........................................................................................................... 14
8.2 Definition of the axes on the machine tools ........................................................................ 17
9 Malfunctions .................................................................................................................................... 17
9.1 The red LED on the CNC controller flashes or flickers. ....................................................... 17
9.2 All axes are no longer triggered. .......................................................................................... 17
9.3 Step motor does not run ....................................................................................................... 17
10 Spare parts....................................................................................................................................... 18
11 Appendix ......................................................................................................................................... 19
11.1 Copyright .............................................................................................................................. 19
11.2 Warranty ............................................................................................................................... 19
11.3 RoHS , 2002/95/EC .............................................................................................................. 19
11.4 Disposal .............................................................................................................................. 20
11.5 Product follow-up ................................................................................................................. 20
11.6 EC - Declaration of Conformity ........................................................................................... 21

Optimum CNC Controller VI Specifications

General

Brand	Optimum
Model	CNC Controller VI
Category	Controller
Language	English