Install the belt
Note 1: To reduce contamination problems, wash your hands prior to handling the drive belt.
- With the platter upside down, place the belt around the hub.
- Bring the platter over the bearing and lower it straight down holding the belt stretched
beyond the machined groove in the platter.
- Guide the drive belt around the motor pulley when the spindle first stop over the oil in the
bearing.
Note 2: Do not attempt to rotate the platter at this time since it is not yet fully seated against
thrust pad. The spindle will first rest over the oil creating an hydraulic lock and the weight of the
platter will gradually allow if to seat against the thrust pad. This whole process should be
completed withtin one minute.
Note 3: In the event that the drive belt becomes contaminated, clean it with denatured alcohol.
Clean the motor pulley and the drive hub at the same time.
Remove the platter with the drive belt installed
-Place one hand at the rear over the motor, one hand at the front, lift the platter about
25cm ( one inch ) and with one finger pull the belt off the motor pulley, then lift the platter
straight up.
Install the dust cover
Note:The hinges are already mounted to the dust cover.
- Slide the hinge flap in the anchor plates at the rear of your Alexandria.
Connect the power supply
- Plug the supply output to the turntable input receptacle at the rear of the turntable.
- Plug the input cord to an AC outlet.
Note: Keep the power supply away from the signal carrying leads
ALEXANDRIA MK III
Owner’s manual
To Next Page
Loading...
Need help?
General
