Orbit 28954 User Manual

Section 3: Programming with
Easy-Set Logic
™
A note about multiple programs
Your sprinkler timer provides the flexibility of using 2
independent programs (A, B). The programs are where
you store all of your sprinkler settings. Each program
consists of a group of stations set to specific start
times and run times. Multiple programs allow you to
run different valves on different days with different
run times. While many applications only require one
program (A), using multiple programs (A, B) can be
useful for drip areas, newly planted lawn, or rotary
sprinkler stations. Using programs to group stations
with similar water needs will maximize irrigation
efficiency.
Primary programming can be accomplished in just a
few basic steps.
Primary Programming
Press the [RESET] to clear any previous factory
programming
1. Set Clock
• Turn dial to [SET CLOCK].
• Press the [+/–] buttons to set the current time of day.
Tip: To increase or decrease more rapidly, hold down
either the [+] or [-] buttons until the display goes into
rapid advance mode.
• Press the [   ] buttons to set am/pm.
• Turn dial to accept time.
2. Set Date
• Turn dial to [SET DATE].
• Press the PROGRAM button to select which
program you’d like to set.
• Press the [   ] buttons to select which stations
you’d like to set
• Y/M/D will appear (blinking letter indicates selection).
• Press the [+/–] buttons to set the correct year,
then press [ENTER] or [   ].
• Press the [+/–] buttons to set the correct month,
then press [ENTER].
• Press the [+/–] buttons to set the correct date.
• Turn dial to accept date.
3. Start time
• Turn dial to [START TIME].
• Press the [+/–] buttons to select time you’d like
your watering to begin. (time will adjust in 1
minute increments)
9

Orbit 28954 Specifications

General

Brand	Orbit
Model	28954
Category	Timer
Language	English