display will show an “A” and the cursor will blink under the
days of week M, T, W, T, F, S, S Monday, Tuesday, etc. [See
Figure 5]
• Press ENTER to activate watering on Monday. An arrow
appears under “M” and the cursor will advance to Tuesday
(“T”), press ENTER to activate watering on Tuesday or NEXT
to skip to the next day. [See Figure 5] Repeat these steps for all
days of the week.
• To delete a previously entered day, press CLEAR.
• If you want to water every second day, press the NEXT key to
advance the cursor to “2nd”, then press ENTER. If you choose
to water every 2nd day, you cannot set specific days of the
week for watering.
Please proceed to the “Automatic Operation” section if a Program
B is not required.
Program B - Interval Watering & Odd and
Even Days
STEP 1. SET THE “START TIME(s)”
Note: The cycle start time is the time the program begins watering the
first station. Cycle start times do not correspond to specific stations.
• Turn the dial to the CYCLE START TIMES position in
“Program B”. The display will show a “B” and a blinking
cursor should be next to “Cycle Start Time 1” (on the left side
of the LCD). If not, push the NEXT key until the curser is
next to “Cycle Start Time 1”.
• Set the time you want to begin watering for start time 1 using
the or keys, then press the ENTER key. The curser
should now be at “Cycle Start Time 2” and begin blinking.
IMPORTANT: Entering additional start times (2 through 4) will
repeat the watering program for the same designated watering day.
Generally, only one cycle start time is required for “Program B”.
For more information on “Multiple Start Times” go to the
“Commonly used Features” section on page 10.
ENGLISH
7
To Next Page
Loading...
Need help?
General
