• To adjust press [+/–] buttons, press [ENTER]
• If using multiple programs (A, B, or C) Press the
[PROGRAM] button to move to the desired program and
make the needed adjustment
Example: Bill’s watering duration is set at 60 minutes
however; it is the spring time so he wants to water half as
long so he sets his budgeting to 50%, his timer will now
water for 30 minutes.
Manual Watering
Your timer has the ability to allow you to manually water
without disturbing the preset program.
• Turn the dial to [AUTO]
• Press the [MANUAL] button. Display will show ABC and
ALL. After a few seconds or by pressing [ENTER] the
timer will begin manual watering
• All stations will water consecutively for their programmed
duration
Note: If the run times have not been set, the timer will not initiate
manual watering and the screen will return to the current time.
• To specify a specific program or stations, Press the [ ]
buttons to select A, B, or C.
• Press [ENTER] to activate
• To select a specific station, continue pressing the [ ]
buttons until desired station number appears
• Press the [+/–] to enter the desired duration from 1 to
240 minutes
• Wait 5 seconds and your station will begin
• To stop Manual Watering press [CLEAR]
• The timer will go back to your original automatic
watering schedule
Section 4: Additional Features
Rain Delay
[RAIN DELAY] allows you to delay your sprinkler timer from
watering for a set period of time. Delay settings are 24, 48, and
72 hours.
• Turn dial to [AUTO]
• Press the [RAIN DELAY] button to automatically delay
watering for 24 hours
• If a longer Rain Delay is desired, press the [+/–]
buttons to increase or decrease the setting.
• Press [ENTER] or wait 10 seconds and the selected rain
delay will begin.
• [CLEAR] button stops the rain delay and scheduled
watering will resume.
• At the end of the selected rain delay amount of time,
automatic watering resumes.
• While in rain delay mode, the timer display will switch
between the actual time and the remaining hours of the
delay, every 2 seconds
Water Budgeting
Water Budgeting is a simple way to adjust your watering
duration to match seasonal watering needs. Water Budgeting
works by increasing or decreasing watering duration for all
stations in each program. Press the [PROGRAM] button to
select the program you wish to budget.
Adjustment range is from 10% to 200% by increments of 10%.
The default value is 100%. The budgeting will remain on the
adjusted range until you change it.
To set budgeting:
• Turn dial to [BUDGETING]
ENGLISH
11
To Next Page
Loading...
Need help?
General
