USE & MAINTENANCE
Simple Operating Tips
You’ll love the way your Oreck cleans under things, and is SO
lightweight and easy to use. The following are a few simple
suggestions regarding its operation:
• When inserting a new disposable inner bag, first puff out
and OPEN the bag.
• When the disposable inner bag is full, replace it.
• Check the disposable inner bag at least once a month.
• Do not run the vacuum over the cord. The revolving
brushroll could damage the cord.
• Use caution when vacuuming over area rug edges and
fringe.
• If at any time the machine does not pick up properly or
makes an unusual noise, stop operation and service.
• Although your upright will pick up pins, paper clips, and
other small objects, it is recommended that these be
removed from the floor before you vacuum. Failure to do
so may result in permanent damage to the motor suction
fan and its housing.
The Belt
The Oreck Magnesium
™
is equipped with the Endurolife
™
Belt,
which is designed for long life and doesn’t need changing.
Motor Protection/Vacuum Shutdown
If the vacuum becomes overloaded, which could occur by
sucking up a large obstruction or on extremely thick carpet,
the electronics are designed to shut down the vacuum. If this
happens, the vacuum will be turned off and the headlights will
flash. To reset the vacuum turn the unit off, wait 5 seconds,
and then turn it back on. If it shuts down again there may be a
large obstruction in the vacuum. See “Stuffing or Blockage”
for the steps on clearing a blockage.
WARNING: Unplug cord from electrical outlet before servicing.
Lubrication
The vacuum motor bearings are factory lubricated and sealed.
Further lubrication is not required.
Brushroll Maintenance
At least once a month, check for and
remove excessive lint, string or hair from
the revolving brushroll. Patented cleaning
grooves on the brushroll will allow easier
cleaning. Wipe the outside of the vacuum
with a damp cloth. Also clean the connector
deflector assembly area, base of vacuum
and fan housing area. If there is dust in the outer bag, vacuum
it or shake it out. A little preventative maintenance will keep
your Upright vacuum looking new and will ensure continued
cleaning effectiveness.
Replacing the Brushroll
The brushroll is designed for long life. Should it ever become worn
or frayed, it can be replaced by an Oreck Authorized Service Center.
Squeaky Wheels
1. Using a small screwdriver, gently slide it under the wheel and pry
the wheel upwards. It should be fairly easy to do.
2. Slide the wheel off the axle.
3. Use petroleum based lubricant, and apply a small amount to the
axle with a Q-tip, spreading evenly on the axle.
4. Slide the wheel back onto the axle.
A
Locked Position
Removing the Battery
1.
Place a quarter in the grooves of the plastic battery cap (A). Rotate
counterclockwise 45 degrees.
2.
Pull plastic battery cap out. The silver round battery is located
inside.
3.
At the top of the battery is located a silver battery contact that holds
the battery in place. With the tip of a screwdriver, lift the contact
up and away from the battery. Once the contact has cleared, the
battery will spring forward for easy removal.
Removing the Battery
1. Insert battery into battery compartment.
2.
Insert plastic battery cap with grooves facing a vertical position.
Place a quarter in the grooves of the plastic battery cap. Rotate
clockwise 45 degrees to lock the cap into place.
1
1
2
2
3
5 6
To Next Page
Need help?
General
