Orion 280gx User Manual

ORION 4100gx
Four Channel Power Amplifier
400 Watts RMS
EQUIPMENT SUPPLIED
POWER
LEADS
POWER ON LEDS
A SIDE
GAIN CONTROL-
A SIDE /
DIN CONNECTOR
B SIDE
DIN CONNECTOR
B SIDE
GAIN CONTROL
DESCRIPTION
The 4100gx contains two pairs of stereo amplifiers
with a separate power supply for each pair of amp¬
lifiers. It has been designed for installations where
space limitations preclude the use of separate stereo
amplifiers. Each of the four channels supplies 100
watts RMS or 400 watts when bridged using ORION
Bridging Module 400 BDG (refer to page 8).
As shown above, two power cable assemblies and
two power leads arc provided (one for each of the
internal power supplies). Each pair of amplifiers must
be grounded separately as shown on pages 32 and 33.
A single blue turn-on wire is used to turn on all four
channels.
V /
4-CHANNEL
AMPLIFIER
POWER CABLE
ASSEMBLIES '
FUSEHOLDERS
/
ii
TWO 30 AMP
FUSES
TURN-ON CONNECTION
WIRE (BLUE)
Output Power Per Channel
with each channel driven
into 4 ohms @12 Vdc . .
SPEAKER
CONNECTIONS
CABLE ASSY
TWO 30 AMP
FUSES
BUTT
SPLICE
'MOUNTING
HARDWARE
SPECIFICATIONS
Distortion:
Typical . .
Maximum
Frequency Response
Signal to Noise Ratio
Input Sensitivity.
Output Sensitivity .
Input Impedance.
100 WRMS
0.006%
0.03%
6 Hz to 30 KHz ±0.5 dB
Better than 110 dB
150 mV to 5 Vrms
4 ohms to 16 ohms
1 OK ohms
Remote Turn-on Current . 50 mA
Current Consumption:
@No Signal. 750 mA
©Maximum Output ... 70 Amps
Voltage Requirements ... 10V to 16V
Damping Factor.Greater than 500
Output Section Slew Rate 30V per microsecond
Stereo Separation.80 dB
Overall Dimensions. 22 x 8.5 x 2.25 Inches
7

Orion 280gx Specifications

General

Brand	Orion
Model	280gx
Category	Amplifier
Language	English