GB
4
3. MENU OPERATION
Press [INDEX] key to display MENU pages. Scroll the MENU by using [V+]/[V-] key, as follows:
TV MODE
SOUND Æ PICTURE Æ DIRECTORYÆ SETTING Æ TUNING
SCT1, RGB , SCT2 , Y/C, AV MODE
SOUND Æ PICTURE Æ SETTING
MENU display disappears about 15 sec. after last selection.
You can also directly select PICTURE MENU by press the [PICTURE MENU] key on remote control unit, select SOUND MENU
by press the [SOUND] key.
3-1 SOUND MENU
Select the Sound menu by pressing the [ MENU ] and [V+] / [V-] key on remote or on TV set .
Pressing the [P+] / [P-] key, highlighted item will move up and down.
1. VOLUME, BALANCE, BASS, TREBLE
Press [P+] / [P-] key on remote or on TV set to select Volume, Balance, Bass or Treble.
Press [V+] / [V-] key on remote or on TV set to adjust these parameter.
Press the [ MENU ] key to confirm your choice.
Press the [ MENU ] key to exit.
Repeat any functions if required.
2. When selected item is AVL (Automatic Volume Leveller), pressing the [V+] / [V-] key, the AVL function can be on or off.
3. When selected item is LOUDNESS, pressing the [V+] / [V-] key, the "LOUDNESS" function can be on or off.
4. When selected item is ENHANCED, pressing the[V+] / [V-] key, the "LISTENING MODE" can be changed between
NORMAL and INCREDIBLE STEREO mode, (if signal received is mono, the effect will be “INCRED.MONO”).
5. When selected item is EQUALIZER, select the desired frequency by pressing the [V+] / [V-] key and adjust it to desired
setting by [P+] / [P-] key.
3-2 PICTURE MENU
Select the Picture menu by pressing the [ MENU ] and[V+] / [V-] key on remote or on TV set .
Pressing the [P+] / [P-] key, highlighted item will move up and down.
1. BRIGHTNESS, CONTRAST, COLOUR, SHARPNESS,
Press [P+ ]/ [P-] key on remote or on TV set to select Brightness, Contrast, Colour, Sharpness or Tint.
Press VOL+/VOL- keys on remote or on TV set to adjust these parameter.
Press the [ MENU ] key to confirm your choice.
Press the [ MENU ] key to exit.
Repeat any functions if required.
NOTE:
TINT is applicable for only NTSC play back only
Use this function to adjust tint of picture for NTSC signal
2. PIC.IMPROVEMENT, pressing the [V+] / [V-] key the function can be on or off.
3. FCC, pressing [V+] / [V-] key FCC can adjust the colour temperature of the picture to
NORMAL Æ WARM (reddish) Æ COOL (bluish)
4.
ZOOM, pressing [V+] / [V-] key ZOOM, can be changed as follows:
AUTOÆ NORMAL Æ EXPAND
To Next Page
Loading...
Need help?
General
