18 | GSG-8 Getting Started Guide orolia.com
9. Maintenance
To extend the life of your GSG-8, a few minor maintenance tasks are recommended.
Recalibrate your GSG-8
Recommended once every 24 months. To recalibrate your GSG-8, you must contact Orolia service.
Clean Filters
Recommended once every 6 months. To clean the filters of your GSG-8, turn off the unit via the power
switch on the rear panel. Open the front panel using the two pin releases at the top of the unit. Open the
filter by releasing the four screws, and clean the filter using compressed air or a dry towel. Replace the filter
cover and close the front panel.
Update Software
The GSG-8 internal software undergoes regular updates. The current version installed on your GSG-8 will
display on the splash screen and can also be found in the Help menu under About Skydel. See the next
section for contact information.
10. Support and Updates
If you encounter a problem with the setup of your GSG-8, do not hesitate to contact Orolia Canada support:
skydel-support@orolia.com
.
-
End of document
-
Front Panel Access Screws
Internal Front Panel Filter Access
To Previous Page
Loading...
Need help?
General
