OWC miniStack
Introduction
4
1.6 Usage Notes
• If the computer enters sleep or hibernation mode, the LED will remain on but will not blink or pulse.
• For the safe removal of your drive and to ensure that no data is lost, always eject or unmount the corresponding
disk(s) from your operating system before powering o. You can use the methods described below to safely
unmount your disk(s).
OS X :
• Drag the icon for the disk you wish to unmount to the trash can; OR
• Right-click the disk icon on the desktop, then click “Eject”; OR
• Highlight the disk on your Desktop and press Command-E.
Windows:
1. Go to the System Tray (located in the lower right corner of your screen). Click on the “Eject”
icon (a small green arrow over a hardware image).
2. A message will appear, detailing the devices that the “Eject” icon controls, i.e., “Safely remove...” Click on
this prompt.
3. You will then see a message that says, “Safe to Remove Hardware.” It is now safe to disconnect
the miniStack from the computer.