Advanced Operations
61
You can specify the position to start transfer (dubbing) of the
program recorded on the disc to the tape.
≥Copy-guarded discs cannot be dubbed. Most discs are copy-
guarded to prevent illegal reproduction and they cannot be
recorded with the following procedure.
Preparation
≥Select the unit viewing channel (or the AV input) on the TV.
DVD
≥Insert the disc containing the program to be copied (l 20).
≥Check the channel. If “TP” channel is selected, transfer (dubbing)
does not work properly.
-
When the “TP” channel is selected on DVD, you cannot select the
“DC” channel.
VHS
≥Insert a video cassette with an intact erasure prevention tab.
(l 48)
≥Confirm that the remaining tape time is sufficient for recording.
(l 57)
[1] Press [DVD] and press [1, PLAY].
Start playing the disc and find the recording start point.
≥Select the audio to be played (the audio to be recorded)
beforehand. [RAM]
≥When the DVD-R is inserted, you cannot select the audio.
[2] Press [;, PAUSE] at the start point of the
recording.
[3] Press [VHS].
[4] Select “DC” channel with [CH, W, X].
≥The DVD picture is displayed on the TV.
[5] Press [1, PLAY].
Start playing the video cassette and find the recording start point.
[6] Press [;, PAUSE] at the start point of the
recording, then press [¥, VHS REC] to pause.
Put the unit in the recording standby mode.
[7] Press [REC MODE] to select the recording
mode.
[8] Press [;, PAUSE].
≥VHS recording and disc play start at the same time.
∫When transfer (dubbing) is started, the following
operations also start automatically:
≥“Status Messages” on Display ) “Off” (l 45)
≥Audio output when playing back DVD ) Stereo (L R)
∫Only the following operations are allowed while
transfer (dubbing):
≥Turning the unit off/on
≥Stopping transfer (dubbing) by pressing [STOP]
Note:
≥When the transfer (dubbing) is already started, you can switch the
output manually.
∫ Manual Transfer (Dubbing)
To pause or stop Manual Transfer (Dubbing)
You cannot stop or pause on DVD and VHS at the same time
∫To pause or stop recording
Press [VHS] and press [;, PAUSE] or [∫, STOP].
∫To pause or stop play
Press [DVD] and press [;, PAUSE] or [∫, STOP].
∫About DC channel
(DC: Dubbing input channel)
≥DC channel can be recorded only when the VHS input
channel is set to “DC”.
≥When you play back a tape with the channel set to “DC”, the
DVD picture is displayed on the TV screen.
VHSDVD
PP-Sample.book 61 ページ ２００４年４月８日 木曜日 午後３時４５分
To Next Page
Loading...
Need help?
General