Panasonic ER1421 User Manual

4
English
Connecting the comb attachment shelf to the charging
stand ER1421
Determine the connection position for the
charging stand and comb attachment
shelf. Firmly insert the connector into the
slot at the bottom of the charging stand.
If the unit wobbles, then further push in
the connector since it has not been
firmly inserted.
•
Charging without the charging stand
1. Slide the 0·CHARGE/1 switch to “0·CHARGE”,
and insert the appliance plug into the clipper.
2. Plug in the adaptor into a household outlet.
AC operation
If you connect the AC adaptor to the clipper in the same way as for
charging, and turn on the power, you can use it even if the battery
capacity is low.
If the clipper does not operate, charge the clipper for
approximately 1 minute.


•
Be careful not to discharge the battery completely with the power
left turned on. It results in shortening the battery life.
Using the hair clipper
Cut
Using the comb attachments
1
1
Select the trimming heights
indicated on the insides and
sides of the attachments.
2
2
Mount the attachment to the
clipper as illustrated.
Removing the attachment from the clipper
Slide one side of the attachment off the
mounting in direction indicated with the
arrow.
•


Panasonic ER1421 Specifications

General

Number of speeds	-
Number of length steps	6
Rechargeable	Yes
Charging time	1 h
Operating time	80 min
AC input voltage	100 - 240 V

Weight and Dimensions

Weight	150 g