5
English
Blade maintenance
Care
Removing and mounting the blade
Removing the blade
1. Hold the clipper with the switch
facing upward and push the
blade with your thumb while
catching the blade in your other
hand.
Be sure to turn off the power
before you remove the blade.
•
Mounting the blade
1. Set the dial to “2.0”.
2. Fit the mounting hook into the
blade mounting on the clipper
and push in until it clicks.
Cleaning the blade
1. Brush off
any hairs
from the
clipper and
from around
the blade.
2. Remove the
blade and
brush off
the hairs
from the
blade edge.
3. Brush the hairs out from
between the stationary
blade and the moving
blade while pressing
down on the cleaning
lever to raise the moving
blade.
Lubrication
1. Apply a few drops of the
oil to the space between
the stationary blade and
moving blade.
Apply the oil to the clipper
before and after each
use.
2. Set the dial to “2.0” and
then remount the blade
on the clipper.
•
To Next Page
Loading...
Need help?
General
Weight and Dimensions
