14
Installation
1. Check the location.
■
Avoid the following locations for installation.
•
Locations with a possibility of freezing
•
Locations exposed to direct sunlight
(To prevent malfunction or deformation)
•
Uneven or unstable locations
(on blocks, timbers, a table with wheels, etc.)
2. Attach the bottom cover.
Preparation: Set a cardboard, etc. and lay the
washing machine on it, avoiding
product damage and deformation.
(Face the front side down.)
1
Insert the bottom cover along
the guides, and set 3 holes to
the corresponding
projections.
Projection
Hole Guide
Hole
2
Fix with screws.
(6 locations for right, left and top)
Screw hole
Water tap
adaptor
Water supply
hose
Water supply
valve screw
Bottom cover
External drain
water hose
3. Attach the external drain water hose.
1
Connect.
Insert all the way.
2
Slide the
hose band
in the arrow
direction.
● Slide all the way
until it stops.
Hose band
NOTE
● Do not put the
hose tip under
water.
● Do not raise the
hose higher than
10 cm above the
fl oor.
10 cm or
less
● Do not extend the
overall length to
more than 3 m.
3 m or less
HOT COLD
To Next Page
Loading...
Need help?
General