5
Precautions for Use
Installation
Thisairconditionermustbeinstalledproperlybyqualied
installation technicians in accordance with the Installation
Instructions provided with the unit.
Before installation, check that the voltage of the electric
supplyinyourhomeorofceisthesameasthevoltage
shown on the nameplate.
WARNING
Avoid the following locations for installation.
Locations where smoke or combustible gas exists.
Also locations of extremely high temperature such as a
greenhouse.
Locations where excessively high heat-generating
objects are placed.
Attention:
Avoid installing the outdoor unit where salty sea water can
splash directly onto it or in sulphurous air near a spa.
(To protect the air conditioner from heavy corrosion)
Wiring
All wiring must conform to the local electrical codes.
(Consultyourdealeroraqualiedelectricianfordetails.)
Each unit must be properly grounded with a ground (or
earth) wire or through the supply wiring.
Wiringmustbedonebyaqualiedelectrician.
Operation Preparation
Turn the power mains on 5 hours before the
start of operation.
(For warm-up)
Leave the power mains ON for continuous use.
NOTE
Pull off the power plug from a receptacle, or switch off the
breaker, or switch off the power disconnecting mean to isolate
the air conditioner from the main power supply when not in use
for a long time.
Disposal of Old Equipment
Only for European Union and countries with
recycling systems
This symbol on the products, packaging, and/
or accompanying documents means that used
electrical and electronic products must not be
mixed with general household waste.
For proper treatment, recovery and recycling
of old products, please take them to applicable
collection points in accordance with your
national legislation.
By disposing of them correctly, you will help
to save valuable resources and prevent any
potential negative effects on human health
and the environment. For more information
about collection and recycling, please contact
your local municipality.
Penalties may be applicable for incorrect
disposal of this waste, in accordance with
national legislation.
Tips for Energy Saving
Avoid
Do not block the air intake and outlet of the unit.
(If either is obstructed, the unit will not function
well, causing malfunction.)
During cooling operation, use sunshades, blinds or
curtains to prevent direct sunlight from entering the
room.
Do
Alwayskeeptheairlterclean.
(Acloggedlterwillimpairtheperformanceoftheunit.)
→“Maintenance”(P.7)
To prevent conditioned air from escaping, keep
windows, doors and any other openings closed.
OI_00_331027_EN.indb 5 2021/9/1 13:03:19
To Next Page
Need help?
General
