Panduit CDE3 User Manual

For Technical Support: www.panduit.com/resources/install_maintain.asp
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2016
V00029KB
Page 4 of 6
Routing of Switch Power Cable
NOTE: Dashed outline of 3 RU Switch is shown for power cord routing reference only.
DO NOT INSTALL SWITCH AT THIS TIME.
Cabinet and equipment rails are not shown to add clarity to view.
Prior to switch installation, route power cord through Switch Ducting and Switch Support Bracket as shown. Slit grommet(s) along guide
lines as needed to allow for power cord pass-through. Use bridge features on Switch Support Bracket as tie-down point(s) to secure
switch power cord to Switch Support Bracket with cable tie.
Switch Ducting
Switch
Support
Bracket
Install Switch
NOTE: Cabinet and equipment rails are not shown to add clarity to view.
Slide the 3 RU Switch onto positioning flanges of Switch Support Bracket. Carefully insert inlet side of switch into rear opening of Switch
Ducting. Position holes of 3 RU Switch rack mount brackets over threaded studs of Switch Support Bracket. Secure switch to Switch
Support Bracket with (6) #10-32 acorn nuts (use 3/8” socket wrench), (6) #10 External Tooth Washers
Switch Power Cord
(to rear-mounted power
outlet unit)
FRONT OF CABINET
Slit Grommet(s) along guide lines as needed
to allow for power cord pass-through
Bridge Feature
(use as tie-down
point for cable tie)
FRONT OF CABINET
3 RU Switch
(reference; port side of
switch faces Hot Aisle)
Positioning
Flange
Rear Opening of
Switch Ducting
(6) #10-32 Acorn Nuts
(use 3/8” socket wrench)
Positioning
Flange
Switch Power Cord
REAR OF
CABINET
(6) #10 External Tooth
Washers

Panduit CDE3 Specifications

General

Brand	Panduit
Model	CDE3
Category	Measuring Instruments
Language	English