5-2
5.Wireless network setup (applicable to Wi-Fi models)
Depending on model, the printer with Wi-Fi printing function supports the two types of
wireless network connection of both infrastructure connection mode and Soft-AP, while
there is usually only one connection between computer and printer at a time. If you
have problems during wireless network setup, please refer to Chapter 5.3 Wireless
Network Setup Frequently Asked Questions.
Basic structure mode: connecting to a
wireless device via router
1. Access point (wireless router)
2. Wireless network printer
3. Computer connecting to access point via
wireless network
4. Computer connecting to access point via
network cable
Soft-AP
The wireless computer is directly connected
to the wireless device.
5.1.Basic structure mode
You can connect a computer to your printer via access point (wireless router) as the medium.
Access point (wireless router) connection is divided into wireless network setup and Wi-Fi
Protected Setup (WPS).
Important: Before wireless network installation, you must learn about the service set
identier (SSID) and password of your access point in order to use them during wireless
network setup. If they cannot be determined, please consult your network administrator or
access point (wireless router) manufacturer.
5.1.1.Wireless network setup tools
If your computer has been installed with a driver and had been connected to wireless
network, but the wireless network was changed, you can set it again with wireless network
setup tools.
5.1.1.1.Preliminary preparations
1. Access point (wireless router).
2. A computer that has been connected to network.
3. A printer that has wireless network function.
To Next Page
Loading...
Need help?
General