10 User Guide
Auto-Arming
The Magellan alarm system can be programmed to automatically arm upon the following two conditions.
Timed Auto Arming
The alarm system can automatically arm itself at a specified time every day. As with Regular arming (see Regular Arming on page 8),
the system will bypass any open zones. Your installer can enable this option, but you can program the time of day the system will
automatically arm.
No Movement Auto Arming
The alarm system can be programmed to arm the system and/or send a report if no zone activity occurs for a pre-programmed
amount of time. This is a particularly useful feature when supervising an individual with chronic health problems or a person who
lives alone. The system will bypass any open zones. This feature must be set by your installer.
Disarming & Deactivating an Alarm
To disarm an armed system or an alarm, press [OFF] and enter your [ACCESS CODE]. An entry point, like the front door, will be
programmed with one of two Entry Delay Timers. When an entry point is opened, the keypad will beep until you disarm the system.
Your alarm system will not generate an alarm until this timer elapses. Any user can disarm a partition they have been assigned to,
except users assigned with the Arm Only Option or PGM Only Option.To disarm alarms generated by a Delayed Fire Zone, refer to
Fire Alarms on page 12.
Manual Bypass Programming
Manual Bypass Programming allows you to program the alarm system to ignore (deactivate) specified zones the next time the
system is armed. For example, you may wish to bypass certain zones when workers are renovating part of your establishment. Once
the system is disarmed, the bypass entries are erased. Manual Bypass Programming can also be activated by using One-Touch
Bypass Programming (see the note below). To remove the Bypass feature from a zone, in step 3 enter the zone number again or
press [
CLEAR] to erase all current entries. When zones are bypassed, the [BYP] key will illuminate.
If One-Touch Bypass Programming is enabled, press the [BYP] key for three seconds to enter Bypass Programming.
Press [
ENTER] after step 2 to bypass all open zones. Press [CLEAR] twice to exit without saving. Press [CLEAR] + [ENTER] to delete bypassed
zones.
How do I program the Auto-Arm Timer?
1. Press the [] key.
2. Enter [MASTER CODE].
3. Press the [BYP] key. The [BYP] key will flash to indicate you are in the System Options menu.
4. Press key [1] to set partition 1, or press key [2] to set partition 2.
5. Enter the desired time for auto arm (24 hour clock, e.g. 18:30).
6. Press key [1] to regular arm, key [2] to sleep arm, or key [3] to stay arm the partition.
How do I disarm the system?
For a Stay or Sleep armed system, go to step 2.
1. Enter through a designated entry point (e.g. front door).
2. Press [
OFF] + enter [ACCESS CODE].
3. If you have access to both partitions (see Partitioning on page 5): Press the key corresponding to the desired partition ([1] or [2]).
For both partitions, press the other key after the confirmation beep.
How do I deactivate an alarm?
Press [
OFF] + enter [ACCESS CODE].
How do I bypass zones?
1. Press the [
BYP] key.
2. Enter [
ACCESS CODE] (see the note below). The [BYP] key will flash.
3. Illuminate the number(s) corresponding to the zone(s) you want to bypass by entering the two-digit zone number (e.g. zone 3 =
03). Solid on = Zone open, Flash = Zone bypass, Off = Zone closed, not bypassed.
4. Press the [
ENTER] key to save and exit.
To Next Page
Loading...
Need help?
General
