PMFW 310 C2
GB│ 7 ■
Sanding plate
Materials:
lumber, metal (sanding sheets included in the
delivery), paints*, stone*
*depending on the sanding sheet
Application:
sanding up to edges and hard to reach areas.
Segment saw blade Z85 C3
Material:
wood
Application:
– separation and plunge saw cuts
– sawing close to edges, even in hard to reach
areas
Example: working parquet and other flooring
materials, also with plunge cuts.
Scraper Z52 B2
Materials:
mortar/concrete residues, tile/carpet glue, paint/
silicone residues
Application:
– removal of material residues, such as tile adhe-
sive, when replacing damaged tiles
Changing tools
NOTE
► If you plan to use the dust collection unit, it
must be connected before fitting or changing
the tool (see section “Connecting a dust
extraction device”).
WARNING! RISK OF INJURY!
■ Always remove the plug from the power
socket before working on the power tool.
■ Check that the tool is fitted firmly. Incorrectly
or insecurely fitted tools can come loose during
use and cause you an injury.
■ If necessary, remove an already fitted tool.
To do this, raise the tool release lever
.
■ Fit the tool (e.g. the plunge saw blade
) onto
the tool holder.
NOTE
► You can fit the tools in any snap position on
the tool holder.
■ Lock the tool into place by pushing the tool
release lever
back down again.
HCS
C
HCS
B2
To Next Page
Loading...
Need help?
General
