16 GB/IE
5 Operation
5.11 Unravelling the hose
Pull the irrigation hose
5
out of the hose box
3
to the desired length (see fig. J).
Allow the hose to follow. The irrigation hose
5
will go back a short distance until it is held
by the retraction block.
Open the tap. Ensure that the spray nozzle
7
is closed.
Open the spray nozzle
7
by turning it to the
right (see fig. K).
The red marking on the hose signifies that you
are coming to the end of the hose. From here,
the hose can only be pulled out a few more cm.
5.2 Re-ravelling the hose
Risk of injury and damage! If the irrigation
hose is not guided, the spring tension of the au-
tomated ravelling system can cause it to spin
around and lead to injury and property damage.
Always guide the irrigation hose by hand. Ensure
that no other people are nearby when re-ravel-
ling.
Never reach inside of the housing.
Close the spray nozzle
7
by turning it to the
left (see fig. K).
Close the tap.
Open the spray nozzle
7
to release the water
pressure. Turn the spray nozzle
7
to the right
to do so. Close the spray nozzle
7
again by
turning it to the left.
Hold the irrigation hose
5
by the spray nozzle
7
. Pull briefly on the irrigation hose
5
to re-
lease the retraction block. Guide the irrigation
hose
5
by hand while it automatically rolls up
to the limit stop
4
into the hose box
3
(see
fig. L).
Swivel the hose box
3
towards the wall to
save space (see fig. B).
To Next Page
Loading...
Need help?
General