To Next PageTo Next PageTo Previous PageTo Previous Page
Need help?Do you have a question about the Peavey Impulse 1012 and is the answer not in the manual?
General| Impedance | 8 Ohms |
|---|---|
| LF Driver | 12" woofer |
| Type | Two-way full-range |
| HF Driver | 1.4" titanium diaphragm compression driver |
| Sensitivity | 98dB SPL (1W @ 1m) |
Details the enclosure type of the Peavey Impulse 1012 speaker system.
Specifies the frequency response in an anechoic environment for 8 and 4 ohm configurations.
Defines the low-frequency limits at -3 dB and -10 dB points.
Details power handling in watts for full range and bi-amp configurations.
Provides SPL ratings in dB for full range and bi-amp sections at 1W/1M.
States the continuous and peak SPL levels for full range and bi-amp configurations.
Specifies horizontal and vertical radiation angles at different frequency bands.
Presents the mean directivity factor Q with tolerance.
Presents the mean directivity index D with tolerance.
Indicates the crossover frequency between the low and high frequency sections.
Lists the low and high frequency drivers used in the system.
Specifies the tuning frequency of the speaker enclosure.
Lists harmonic distortion percentages for 10% and 1% rated power.
Defines the type of internal passive crossover used.
Details the crossover slope for low pass and high pass with EQ.
Suggests active crossover settings for bi-amping.
Specifies the time offset for low and high frequency signals.
Provides nominal and minimum impedance values for different configurations.
Describes the available input connectors, including Neutrik and phone jacks.
Details the materials and finish of the enclosure.
Lists the available mounting options and hardware.
Provides the front and rear dimensions of the speaker system.
States the net weight of the loudspeaker system.
States the shipping weight of the loudspeaker system.
Notes the availability of a biamplified powered unit.
Highlights the main features of the Impulse 1012 speaker system.
Provides an overview of the Impulse 1012 as a two-way full-range speaker system.
Plots harmonic distortion for 10% rated power.
Plots harmonic distortion for 1% rated power.
Explains how the frequency response is measured and what Figure 1 shows.
Explains beamwidth, Q, and Directivity Index from polar plots.
Explains Peavey's power handling rating methodology using AES Standard 2-1984.
Explains how harmonic distortion is plotted and interpreted from graphs.
Details specifications for both 4 ohm and 8 ohm versions of the loudspeaker.
Warns about the risks of improper suspension and mounting.
Refers to warranty statement details available from Peavey Electronics.
Displays horizontal polar patterns at various frequencies from 250 Hz to 1.6 kHz.
Displays horizontal polar patterns at various frequencies from 2 kHz to 16 kHz.
Displays vertical polar patterns at various frequencies from 250 Hz to 1.6 kHz.
Displays vertical polar patterns at various frequencies from 2 kHz to 16 kHz.
Illustrates the bi-amp wiring connections for Speakon connectors.
Warns about danger from improper suspension and mounting of the speaker.
Warns about potential hearing damage from high loudness levels.
Provides dimensional drawings for top mounting provisions.
Provides dimensional drawings for bottom mounting provisions.
