Peavey TransTube Series Manual

.
7.
PRE
GAIN
Controls the
input volume
level
of the Lead
channel. The Pre
Gain
can be used to
control the
distortion
level in the
Lead channel.
To
obtain more distortion
simply
increase the Pre
Gain
and set
the Post
Gain
(8)
to the
desired volume
level.
8. POST
GAIN
Controls
the
overall volume level
of the
Lead channel.
The final level
adjustment
should
be
made
after the
desired sound has
been
achieved.
9. CDTTAPE
INPUT
The
CD/TAPE
INPUT can
be used
to route the headphone
out signal of
a CD
player,
tape
player,
etc. into
your
Blazer/Rage
amplifier. Connect
the CD
or tape headphone
output
using
a shielded
cable to the
CD/TAPE INPUT
jack.
This
signal is mixed
with
the
guitar
signal but
is not
affected
by the EQ.
10.
MODERNruINTAGESWITCH
This
switch
allows
you
to instantly
change the voicing
to reflect
the tones
of modern
and
vintage
amplifiers. The
"MODERN"
position
maintains
a warm,
standard voicing.
The
"VINTAGE"
position
changes
the
overall
function
of the EQ
and adds a hint
of brightness
to emulate
some classic
amp designs.
Experiment
with this
switch, along with
the EQ
(11)
adjustments,
to capture
your
desired
tone. You may
refer to the
Recommended
Settings on
page
6 for
some creative
starting
points.
11.
LOW MID
AND HIGH
EQ
Passive
tone
controls that
regulate
the low, mid
and high frequencies,
respectively.
12, HEADPHONE
JACK
This
stereo
jack
allows
signal to flow
to both
sides of
any stereo headset.
A monaural headset
may
be
used, but it is
not recommended.
13.
REVERB
LEVEL
(Applicable
to Btazer 158
onty)
Controls the
overall reverb
level.

Peavey TransTube Series Specifications

General

Brand	Peavey
Model	TransTube Series
Category	Amplifier
Language	English