Peavey TransTube Series Manual

RAGE'
1s8/BLAZER' 158
REAR PANEL
AC POWER CORD
(Under
chassis)
This line cord
provides
the AC
power
to
the
unit. Connect
the line cord to a
properly
grounded
AC supply. Damage to the equipment
may
occur
if improper line voltage is
used.
(See
voltage marking on unit.) Never remove or cut the
ground pin
of the
line
cord
plug.
NOTE: FOR UK ONLY
As the colors of the wires
in
the
mains lead
of this apparatus
may not
correspond
with
the colored
markings identifying the terminals
in
your plug, proceed
as
follows:
(1)
The wire which is
colored
green
and
yellow
must be connected to the terminal which
is
marked by the letter E, or by the earth
symbol, or colored
green
or
green
and
yellow.
(2)
The wire which is colored blue must be connected
to the terminal which is marked with the leiter N, or the color black.
(3)
The wire which is colored
brown must be connected to the terminal which is marked with the letter L or color red.
2.
3.
4.
POWER SWITCH
Press the switch to the
"ON"
position
to apply
power
to the unit. The POWER LED
(3)
will
illuminate to indicate
power
has been
supplied
to the
unit.
POWER LED
llluminates when
power
has been supplied to the unit.
INPUT
Input
jack
will accept signals from
all
types
of
guitar pickups.
Be
sure to use a high
quality
shielded instrument cable to connect the
guitar
to the
amplifier.
VOLUME
Controls the volume level of the Clean channel and is not affected
bv the Lead. Pre or Post
Gain controls.
CHANNEL
SELECT SWITCH
Allows
selection of the Lead or Clean channel. The
"down"
oosition of the switch selects the
Lead channel
and
the
"up"
position
selects the Clean channel.
5.
6.

Peavey TransTube Series Specifications

General

Brand	Peavey
Model	TransTube Series
Category	Amplifier
Language	English