For your convience, PEG PEREGO offers after-sales service, directly or through a network of authorized service
centers for repairs or replacement parts.
If you have any questions about your Peg Perego vehicle, please call our toll-free service lines at;
U.S.A , call 1-800-728-2108
CANADA, call 1-800-661-5050
Trained customer service representatives are available to take your call in English or Spanish.
CUSTOMER SERVICE
IF THE VEHICLE DOES NOT OPERATE?
•When operating in overload conditions, such as running the vehicle against a fixed object,
through soft deep sand or mud, or over rough or uneven terrain, the overload circuit
breaker will automatically disconnect the power. After 30 or more seconds, the circuit
breaker will automatically reset, however-you must eliminate overload conditions to
resume normal driving.
•Press the accelerator pedal to activate the vehicle, followed by a single BEEP that indicates the toy is ready to
operate.
•If you let the vehicle idle for more than 10 minutes must repeat the activation process, simply by pressing the
pedal waiting for the BEEP.
•If during riding, the vehicle emits a CONTINUOUS BEEP must recharge the battery.
•If no initial beep is heard, the battery is low and must be charged.
•If the problem persists after recharging, to check the battery and the charger to a service center.
•Check that all plugs are properly connected.
•Check electrical switches. Replace if necessary.
•Check that the battery is connected to the electrical system.
IF THERE IS NO POWER?
•Fully recharge the battery. If the problem persist, check with an Authorized PEG PEREGO Service Center.
PROBLEMS?
In reference to the radio:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority
to operate the equipment.
FCC STATEMENT (United States Only)
To Next Page
Loading...
Need help?
General
